Molded Fiberglass Patterns & Screens
Product Overview
All FRP grating should be securely fastened to its supporting structure to protect the grating and increase product service life. Specialty clips manufactured from type 316 stainless steel are available for all fiberglass products. Clips can be used to attach grating or plate to the supporting structure or fasten adjacent grating panels to minimize load induced differential deflection.
Maximum recommended clip spacing is 48 inches on center with a minimum of four (4) clips per piece of grating.
Fiberglass Grating Fasteners
Type “M” Saddle Clip
Used to secure molded or pultruded panels to a support using two adjacent bearing bars. Bolt not included with standard clip order.
Type “J” Hold Down Clip
Used to secure molded grating to a support using one bearing bar. Bolt not included with standard clip order.
Type “F” End Panel Clip
Used to connect adjacent molded FRP Panels. Fastening bolt included with clip order.
Type “E” Hold Down Clip
Specifically designed to attach Ecograte62 molded grating to supporting structures. Bolt not included with standard clip order.
Type “FC” Hold Down Clip
Type “FC” clips are used to secure pultruded grating to adjacent supports. Bolt not included with standard clip order.
Type “G” Friction Clip
Used to attach molded or pultruded grating to support flanges that are less than ¾” thick. Type “G” Hold Down clips are a friction clip and do not require drilling into the support flange. Fastening bolt included with clip order.
Type W Clip
Used to secure covered grating or plate to supporting structures. Bolt not included with standard clip order.
Type WLP Clip
Used to secure covered grating or close mesh FRP grating to supporting structures. Bolt not included with standard clip order.